Brother printer error

Brother printer error message on the status monitor

Brother printer error message on the status monitor

Table Of Contents

 

A wrong network frequently causes the problem. Check the network
connectivity to resolve the issue. Follow the power-cycle
instructions to restart your printer. This method often addresses
several printer troubles.

 

1. Brother printer error

“Error 30” or “Unable to Print 30”

One of the most prevalent Brother printer error messages is Error 30.
The error number 30 and the message “Unable to Print” indicate that
the printer cannot print due to a mechanical problem. An object
becoming stuck in the machine, such as a paper clip or a piece of
paper, is another probable cause of this error.

If your Brother printer won’t print and the warning “Unable to Print
30″ displays, use the troubleshooting methods below to resolve the
issue: Lift the scanner spread into an open space with both hands,
being accurate to view the scanner cover provider arm on the
machine’s left side.

Check both the right and left corners of the machine for any objects
that have become stuck in the device, such as paper scraps or paper
clips. Turn the printer around and open the clear jam cover on the
back to check for foreign items or remove the jammed paper. Close
the lids and resume the printing operation once all objects have
been removed.

2. Brother printer error

“Error 35” or “Unable to Print 35”

The error message “Powerless to Print 51” is a frequent Brother
printer error message that indicates a laser unit failure.

If you’ve recently changed the cartridge in your Brother printer,
likely, the cartridge, laser, or lid were not correctly installed.
To fix the problem, reopen the printer and double-check that
everything is in place.

If you haven’t changed the cartridge and are still getting error
number 51, try turning it off and on the printer. If the problem
persists, a component of the laser unit may be broken. The issue can
be resolved by replacing the laser unit.

3. Brother printer error

“Error 50” or “Unable to Print 50”

The fuser unit is malfunctioning, according to Brother error 50. This
could be due to the fuser unit becoming too hot during printing or
failing to heat up sufficiently to print. The printer is unable to
print as a result.

Turn the printer off and wait five to ten minutes to fix the
problem. After that, switch the printer back on and wait another ten
minutes. If error 50 persists, your Brother printer’s fuser unit may
need to be replaced.

4.Brother printer error

“Error 51” or “Unable to Print 51”

The error message “Unable to Print 51” is a frequent Brother printer
error message that indicates a laser unit failure.

If you’ve recently changed the cartridge in your Brother printer,
likely, the cartridge, laser, or lid were not correctly installed.
To fix the problem, reopen the printer and double-check that
everything is in place.

If you haven’t changed the cartridge and are still getting error
number 51, try turning it off and on the printer. If the problem
persists, a component of the laser unit may be broken. The issue can
be resolved by replacing the laser unit.

5. Brother printer error

“Error TS-02”

 

  • Make sure that your WLAN router works appropriately and that the
    internet connection is established.
  • Place the Brother printer close to the WLAN access point or
    router to improve the network’s relationship.
  • Make sure that the MAC address of the printer is allowed in the
    filter of your router’s MAC address filtering.
  • Check if your Brother printer and your system are using the same
    range of radio signals.
  • Another possible solution is to use the Setup Wizard option of
    your Brother printer to establish the connection.
  • After completing the troubleshooting steps above, restart your
    printer. The error code TS-02 should now be gone.

Related Post